Home Home Stories Stories Library Library Links Links
News News Search Search Forum Forum Shop Shop

 
 Print   Mail
this article
 
 » Sitemap
TVOX Stories
 
Dimensions of the RCA Oscillator
 
 

Both RCA oscillators are identical, two-layer coils wound on a tubular fiber form about 1.5" diameter by 1 3/4" long.

The wire is single silk covered ("SSC") enameled wire approximately #30 B & S gauge.

Turns per layer- about 75.

The winding length is around 1 3/4"

A couple of turns of black "book cover cloth" is wrapped between layers.

Inductances: inner layer =158uH actual. Outer layer= 177uH actual.

Note: The inner and outer inductances are unmatched because the outer layer, having a greater diameter, happens to offer more inductance.

General hook up: The coil layers are wound in opposite directions. To wit:
If the inner layer is CW, the outer layer is CCW. Also, the oscillator system will not work if any one layer is connected in reverse.

RCA stock connections:

  • Inner layer "start" goes to cathode. The '27 cathode is standing on a bypassed 5k resistor to ground.
  • Inner layer "finish" goes to the grid.
  • Outer layer "start" goes to the bypassed B+ rail.
  • Outer layer "finish" goes to the plate.
Note: As said before, if connections of either layer are reversed there can be no oscillation. OTOH, the layers are interchangeable, but that's not necessarily optimal.

RCA uses a cap of about 1100 pF between grid and plate on each of the fixed and variable oscillators. About 50pF of adjustable capacitance is in parallel with the larger C for the purpose of trimming oscillator frequency. The frequency runs about 175kHz.

RCA-style oscillators are easy to make. The first (and only) ones I've made were wound on the paper tube core from a roll of towels. These operate today in the Stout. I merely approximated the RCA specs, using smaller wire (32 DCC) and a little less inductance (150uH) than the RCA and a C of about 900pF. The frequency is 212kHz.
Larger wire is surely a good idea.

An LCR meter is handy if you work with coils. Equally valuable is a frequency counter. The Radio Shack 22-168A multimeter measures frequencies up to 1mHz.

Place theremin oscillator coils as far apart as possible (six inches minimum) and preferably not on or near a metal chassis. Orient the coils 90 degrees from each other. Oscillators drift with the slightest temperature change, so if there is a slow, continuing temperature rise inside the cabinet pitch drift will continue indefinitely.

[Copyright 1997 by Reid Welch]



 

Comment List

There are no comments.
 
 
Copyright 2001-2006 © Valerio Saggini. - Privacy Policy - Feedback